Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Starting Problems
03-28-2008, 05:40
Post: #1
Starting Problems
Quite often I am unable to srart my coach ('85 PT36) from the front
position. When that happens I have been able to start from the rear
position.

The first thing I suspected was the rear toggle switch. That has been
eliminated as has the anti theft switch on the dash. If I disconnect
the wires from the a/t switch I can see 12v coming from the front
ignition sw. when turned to the 'start' postion. I can also see the
ground coming from the starter ckt. solenoid on the other wire. So it
appears I have good circuitry.

This problem seems to happen when the batt. voltage is below 12v.
If I start the generator, with the increase in voltage I can start it
normally from ther front.

Could I have a weak solenoid? Where is this solennoid located?

Located in the 'files' section is a diagram of the start circuit for
my coach. This is what I've been working from.


Art Weatherly
Riverside Ca.
'85 PT36

Anyone have any thoights on this problem.
Quote this message in a reply
03-28-2008, 07:44
Post: #2
Starting Problems
I don't know if this will help or not.
Recently, my starter was acting up(or so I thought). The coach finally went dead while starting it. My manual battery master switch was failing and finally burned out. I replaced it and cleaned all the main grounds around the engine. The starter really spins the engine now. It started fine last weekend without preheat at 29 degrees. I think my solenoid is on the right side of the engine up about half way in the engine bay.
Leroy Eckert
1990 WB-40 Smoke N Mirrors
Dahlonega, GA

amweath wrote:
Quite often I am unable to srart my coach ('85 PT36) from the front
position. When that happens I have been able to start from the rear
position.

The first thing I suspected was the rear toggle switch. That has been
eliminated as has the anti theft switch on the dash. If I disconnect
the wires from the a/t switch I can see 12v coming from the front
ignition sw. when turned to the 'start' postion. I can also see the
ground coming from the starter ckt. solenoid on the other wire. So it
appears I have good circuitry.

This problem seems to happen when the batt. voltage is below 12v.
If I start the generator, with the increase in voltage I can start it
normally from ther front.

Could I have a weak solenoid? Where is this solennoid located?

Located in the 'files' section is a diagram of the start circuit for
my coach. This is what I've been working from.

Art Weatherly

Riverside Ca.
'85 PT36

Anyone have any thoights on this problem.





Never miss a thing. Make Yahoo your homepage.
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)