CC5 Air Cylinder

[Ernie E]

I get no throttle power and have ordered a maintainence kit for this cylinder.
Does anyone have a schematic that shows the workings of this cylinder. I get NO
smoke when I try to accelerate, thus equals NO power. It will air up and oil and
water are fine. Thanks, Ernie- 83PT40 in Texas

[Curt Sprenger]

Ernie,
See page 8. Sent to your private email. I believe I uploaded this to the Wanderlodge site a couple years back.

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, CA

On Tue, Aug 10, 2010 at 2:56 PM, Ernie E <"ernietex@yahoo.com"> wrote:

 

I get no throttle power and have ordered a maintainence kit for this cylinder. Does anyone have a schematic that shows the workings of this cylinder. I get NO smoke when I try to accelerate, thus equals NO power. It will air up and oil and water are fine. Thanks, Ernie- 83PT40 in Texas

[mcmike1952]

Ernie, Make sure the high idle switch is not on. Mike

--- In WanderlodgeForum@yahoogroups.com, "Ernie E" wrote:
>
> I get no throttle power and have ordered a maintainence kit for this cylinder.
Does anyone have a schematic that shows the workings of this cylinder. I get NO
smoke when I try to accelerate, thus equals NO power. It will air up and oil and
water are fine. Thanks, Ernie- 83PT40 in Texas
>

[Ernie Ekberg]

made sure of that and also made sure my Jake was off Ernie Ekberg 83PT40 Wanderlodge Weatherford, Tx 817-475-3991 www.ernieekbergflooring.net --- On Wed, 8/11/10, mcmike1952 <mmcmahan1952@...> wrote: From: mcmike1952 <mmcmahan1952@...> Subject: [WanderlodgeForum] Re: CC5 Air Cylinder To: WanderlodgeForum@yahoogroups.com Date: Wednesday, August 11, 2010, 10:20 AM Ernie, Make sure the high idle switch is not on. Mike --- In WanderlodgeForum@yahoogroups.com, "Ernie E" wrote: > > I get no throttle power and have ordered a maintainence kit for this cylinder. Does anyone have a schematic that shows the workings of this cylinder. I get NO smoke when I try to accelerate, thus equals NO power. It will air up and oil and water are fine. Thanks, Ernie- 83PT40 in Texas >