Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Newly Purchased 82FC33 with No Dash Air Belt...Pulley Conversion for Alternator
03-28-2007, 02:40
Post: #1
Newly Purchased 82FC33 with No Dash Air Belt...Pulley Conversion for Alternator
I am the proud new owner of a near mint 82FC33. Like a lot of FC's my
AC belt is off due to belt throw problems as is so common. I have
heard about using a 7/8" bore, 3 groove pulley (possible a Mack part??)
on the alternator and running the AC for the dash off of it. I am
really having a hard time coming up with a part number. Any help would
greatly be appreciate.

TIA,
Joe
Quote this message in a reply
03-29-2007, 01:46
Post: #2
Newly Purchased 82FC33 with No Dash Air Belt...Pulley Conversion for Alternator
Joe,
I agree with what Crit said. When we got our 84FC I found out the compressor
was siezed
and replaced that. Had an A/C guy go over it and add freon a couple of times
and found
out there were hose leaks between the roof condenser and the compressor. Got an
estimate to replace hoses of $2,000 from Bleakley. Decided to take that money
and put it
toward a new diesel generator to replace my old LPG unit. Now we go down the
road in
the summer with the generator and the roof A/C's running and very comfortable.
Dash air
will only keep you cool up front on a really hot day. Moral of the story is, be
careful not to
throw too much money at an old system that is marginally functional.

All that said, I've heard others say their systems work fine and they like em.
So there you
are, fair and balanced reporting, now you decide. Just like on Fox News.

Regards, Eric in San Antonio
84FC35SBWL2



--- In WanderlodgeForum@yahoogroups.com, "Joe" wrote:
>
> I am the proud new owner of a near mint 82FC33. Like a lot of FC's my
> AC belt is off due to belt throw problems as is so common. I have
> heard about using a 7/8" bore, 3 groove pulley (possible a Mack part??)
> on the alternator and running the AC for the dash off of it. I am
> really having a hard time coming up with a part number. Any help would
> greatly be appreciate.
>
> TIA,
> Joe
>
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)