Bad factory wiring: Follow Up

[Scott Forman]

You may have seen my earlier message about what appeared to be factory
wiring incorrectly run that was preventing by chassis heat from
functioning.

After additional wire chasing, I discovered that the problem that had
disabled the chassis heat was simply a wire that had come loose from
the winter/summer switch on the dash. Once re-connected, the chassis
heat works perfectly.

HOWEVER: while everything now works, the wiring at the curb side load
centers, both front and rear, does not match the schematics in the Blue
Box. I have rechecked it several times to verify that I am seeing what
I think I am seeing.

So what does that mean? I have no idea. Just found it interesting and
thought I would share it with the group.

Scott Forman
82 FC35RB
Memphis

[Jeff Miller]

Scott:

Be sure that the wiring diagram you have in the box is for the rear
bath, there is a difference.

Also, the wooden box that covers the breakers should have a small
version of the diagram attached to the inside.

- Jeff Miller
in Holland, MI


--- In WanderlodgeForum@yahoogroups.com, "Scott Forman"
<sforman@r...> wrote:
>
> You may have seen my earlier message about what appeared to be
factory
> wiring incorrectly run that was preventing by chassis heat from
> functioning.
>
> After additional wire chasing, I discovered that the problem that
had
> disabled the chassis heat was simply a wire that had come loose
from
> the winter/summer switch on the dash. Once re-connected, the
chassis
> heat works perfectly.
>
> HOWEVER: while everything now works, the wiring at the curb side
load
> centers, both front and rear, does not match the schematics in the
Blue
> Box. I have rechecked it several times to verify that I am seeing
what
> I think I am seeing.
>
> So what does that mean? I have no idea. Just found it interesting
and
> thought I would share it with the group.
>
> Scott Forman
> 82 FC35RB
> Memphis
>

[Scott Forman]

They are for rear bath.

Scott

--- In WanderlodgeForum@yahoogroups.com, "Jeff Miller"
wrote:
>
> Scott:
>
> Be sure that the wiring diagram you have in the box is for the rear
> bath, there is a difference.
>
> Also, the wooden box that covers the breakers should have a small
> version of the diagram attached to the inside.
>
> - Jeff Miller
> in Holland, MI
>
>
> --- In WanderlodgeForum@yahoogroups.com, "Scott Forman"
> <sforman@r...> wrote:
> >
> > You may have seen my earlier message about what appeared to be
> factory
> > wiring incorrectly run that was preventing by chassis heat from
> > functioning.
> >
> > After additional wire chasing, I discovered that the problem that
> had
> > disabled the chassis heat was simply a wire that had come loose
> from
> > the winter/summer switch on the dash. Once re-connected, the
> chassis
> > heat works perfectly.
> >
> > HOWEVER: while everything now works, the wiring at the curb side
> load
> > centers, both front and rear, does not match the schematics in
the
> Blue
> > Box. I have rechecked it several times to verify that I am
seeing
> what
> > I think I am seeing.
> >
> > So what does that mean? I have no idea. Just found it
interesting
> and
> > thought I would share it with the group.
> >
> > Scott Forman
> > 82 FC35RB
> > Memphis
> >
>