Generator, step, light switch questions.

[davidkerryedwards]

I dont see the pressure sensing switch on mine. At least there are no
wires going to the step itself. Since none of the switches in the box
to the left of the steps are working, I'm going to start with the
assumption that it is a common problem. When the step started working
while going down the road, the footwell light started working at the
same time. I didn't check the generator switch to see if it was
working when the other two were. The two switches I see in the door
frame are high up on the right hand side. Just push buttons like a
refrigerator light switch.

Kerry
82 FC 35
Denver

--- In WanderlodgeForum@yahoogroups.com, "Jon" wrote:
>
> --- In WanderlodgeForum@yahoogroups.com, "davidkerryedwards"
> wrote:
> >
> > I've asked a similar question before, but I'm going to rephrase.
> The
> > generator slide, step and step light switch are all not functioning
> in
> > my coach. It's likely the problem is a common one--lack of
> voltage?
> > Are all three on one fuse or circuit breaker? If so, where is it?
> If
> > not, can anyone suggest where the problem in voltage delivery may
> lie?
> >
> > Kerry
> > 82 FC 35
> > Denver
> >Kerry I just went threw this ordeal but I do not have generator
> slide.
> May I suggest you remove the toggle switch by the door and see if you
> have power to that switch? If you do then go down to the step switch
> that is the one that looks like a button located on door frame. You
> can
> pull this out easily and check to see if you have power to that
> switch and the
> other side of that switch. On that last switch there should be a
> wire
> that runs down and under the step entrance. This wire connects to a
> pressure sensing cable that looks like a heater strip. On mine the
> strip was shot and was grounding the whole system out. You can
> remove
> this device or just remove the wire to that switch on the door. Try
> that and see what happens. Just in case I didn't explain this good
> enough just remember on that button switch should be one wire to and
> two that lead away. One of those leads are for that pressure sensing
> tape I told you about.
>
> Jon
>
> Jon
> Rebel Bird
> Bremerton Washington
>