Generator, step, light switch questions.

[davidkerryedwards]

Thanks for that crucial information. Turns out the nut on the stud to
which the wires for the step are attached in the load center was
missing, resulting in an intermittent connection. Put a nut on the
stud and the step worked fine. I'm parked too close to the adjacent
RV in the storage lot to test the generator slide, but I'm thinking
that problem is also most likely solved.

Kerry
82 FC 35
Denver

--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> Kerry:
>
> The breaker for those circuits is located in the right front load
center.
> That is the one next to the tv switch over compartment on the curb
side.
> You may simply have lost the ground to the switch. Check to be sure the
> relay in the change over compartment by the steps in the entry way is
> plugged in and the wiring is intact there too.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> Ralph's RV Solutions, Duncan, Oklahoma
> http://home.swbell.net/rlf47/index.htm
>
> At 02:43 PM 3/30/2006 +0000, you wrote:
> >I've asked a similar question before, but I'm going to rephrase. The
> >generator slide, step and step light switch are all not functioning in
> >my coach. It's likely the problem is a common one--lack of voltage?
> >Are all three on one fuse or circuit breaker? If so, where is it? If
> >not, can anyone suggest where the problem in voltage delivery may lie?
> >
> >Kerry
> >82 FC 35
> >Denver
> >
> >
> >
>