Do Not Shift light

[trautoranch]

Kevin, Thank you
for the information . We have started and restarted with no look.
There is no lights flashing to be able to read codes.
Best Regards,
Rick & Terri
86PT38
Patillo,Tx













>
> Rick and Terri,
>
> This has happened a few times with my BB too. Always while
driving, and when trying to upshift from 1st to 2nd. There is some
kind of microprocessor with the Allison trans, and my handbook says
to turn the motor off, removing power from the trans computer, and
re-starting which allows it to "re-boot", for the lack of a better
term. Each time this happened to my BB, the problem corrected
itself after turning the bus off, waiting a minute or so, and
restarting. If the problem persists, I recommend it being looked at
by an Allison repair shop....they might be able to read the codes
from the blinking light below the shift buttons.
>
> Good luck...
>
> Kevin McKeown
> Yorba Linda, CA
> 1986 38' PT
>
> -----Original Message-----
> From: trautoranch
> To: WanderlodgeForum@yahoogroups.com
> Sent: Thu, 20 Apr 2006 03:32:03 -0000
> Subject: [WanderlodgeForum] Do Not Shift light
>
>
> She started just great then noticed "Do Not Shift" light was on,
on the
> shift selector. Never seen that light before. Looked in the blue
book
> and found no reference. Checked all the fluids and jacks, but
found no
> problem. Has anyone had this problem before? Would appreciate
any
> input. We were about to pull out for the Lone Star BB rally.
>
> Rick & Terri McIntire
> 1986 PT38 8V92
> Patillo,
> TX
> Please Help!
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>