Making Noise when Making Noise Isn't Really Do

[Gregory OConnor]

Maybe no gasket is required if the surfaces are true I wonder if DD
puts one on in production???. Thanks for the stretch bolt tip, makes
sence. I always check the thread socket to see that the bolt will
not bottom out from being too long or having debris in the socket
from scraping the gasket. If the bolt is close I run a nut on it and
grind the bolt down. removing the nut helps clean the thread so the
bolt wont cross when reinstalled.

I think Hank and George bring up a good question, the cause of the
failure? Hank hints to who, George hints to what.

I alway feel sorry for repair shops that get hit by one of those TV
Stings where an Actor comes in with a blown fuse. The shop that
replaces the fuse and slams the hood shut is praised. The shop that
spent two hours looking for a problem that never existed and would
have been found in 15 min if it did exist is marked . IMO the good
shop looked for the 'cause of the failure'. But there are bad shops
Like Hemet Chrysler.

Gregory O'Connor by order staying 200 ft from HC
94PT40