Air Conditioner Problem

[Lee Davis]

I actually did that with a leaf nozzle on my water hose and water came out
the air conditioner on top of the bus and ran down the side (so I knew the
line was clear)and back down the hose to drain what did not go out the top.
Unfortunately, when I tried the air conditioner next, no improvement, the
water still comes out in the cabinet.



Any other ideas?



Thanks,



Lee



_____

From: WanderlodgeForum@yahoogroups.com
[mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of Marv & Jean
Sent: Wednesday, June 14, 2006 7:17 PM
To: WanderlodgeForum@yahoogroups.com
Subject: [WanderlodgeForum] Re: Air Conditioner Problem



Lee:

The "red" tubing has probably become plugged with debris. I would
take a air hose and blow back up the tube from where it exits behind
the rear wheel. I'll wager that will fix the problem.

Good luck.

Marv
2004 M380
Ocean Shores, WA

--- In WanderlodgeForum@
yahoogroups.com, "Lee Davis"
wrote:
>
> I am assuming Wanderlodges and BMC's are the same when it comes to
a problem
> like this
>
>
>
> I just purchased a 1995 - 37 ft BMC. My rear air conditioner
leaks water
> through one of the top curbside cabinets next to the Bedroom TV.
Bluebird
> told me it is supposed to come out the red tubing which exits down
by the
> back wheels. (the front air does that through the red tubing
behind the
> fron wheel). Bluebird says the red tubing in the back must have
become
> disconnected in some way and they say I need to take off the
plastic grate
> on the inside, remove the ceiling panel, and then carefully cut a
hone in
> the 4x8 sheet of plywood behind that ceiling panel (with a circular
saw set
> not to protrude through the plywood and cut any wires, etc). that
sounds
> like a bad way to go in my opinion. Because a very small amount of
water
> does come through the tubing, I thought perhaps the cups they have
installed
> around the air conditioner to divert the water to the tubing may
have become
> disturbed in some way. I thought I might need to take the air
conditioner
> off the top to fix that and that may be a better way to go then
the inside
> program. Has anyone ever had a problem like this and if so, what
is the
> best way to try to fix it. Thanks in advance for any help
>
>
>
>
>
> Lee Davis
>
>
>
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]