HWH leveling jacks

[Gregory OConnor]

Phil, Pull it off and drop it at 'O rings and Things' (800) 244-4614
in Fontana across from the California SpeedWay.( If you get out this
way on Business) If you split the ram they will check the cylinder
walls to advise if a repair vs $250.00 replace is necessary while you
are in the shop. You may want to bring along the HWH fatory phone
number in the event Oring needs info. Some times the rod gets a scar or
the cylinder walls get buggered up by water or gunk and blows the seal
or the seal just gets old with low use.If it is an old issue there may
be more leaking to follow and a local repair shop to do the seal
replace without shipping may be the way to go. I have a Tilt ram on a
tractor with factory rebuild of $445.00, ORings repacked the ram for
$72.00

Tim and I look forward to the next Rally you have planned. It will be
good to see Christina again. We have our reservations

Gregory O'Connor
94ptRomolandCa
--- In WanderlodgeForum@yahoogroups.com, "iwander_85pt40"
wrote:
>
> Hi all,
>
> I have an oil leak out the bottom of one of my front kick down jacks.
> I'm assuming the 'o' ring is bad (most likely old age), and needs to
be
> replaced.
>
> Has anybody been involved with this type of repair? Based on your
> experience, would you recommend rebuilding the jack or replacing it
> with another unit?
>
> Phil Corpus
> 'iWander'
> 85PT40
> Left Coast, Southern California
>