ridewell air suspension system.

[Curt Sprenger]

Jim,
You going to attend the October rally in Buellton?

Curt Sprenger 1987 PT38, Anaheim Hills, Calif.



bluebird3208 wrote:

> After replacing the Forward heigth control valve, I took a good look
> at all the air componets hidden in the frame of a 82 FC. There is a
> check valve and back pressure regulator on the cross seciton near the
> air dryer. This is the part tht appears to prevent air usagae of all
> aplinaces including the air bags if the pressure goes below 65 psi.
> On the forward cross member where the height control valve is located,
> there is one of the three air supension dump valves ( the other two
> are at the cross member behind the rear air bags.) on the passengers
> side of the cross member. Looking along the cross member toward the
> drivers side is a tee with the suspension dump sender for the light on
> the dash. Next dead center is a module above the Height control valve
> that I have no idea what it is for. Then comming around the corner
> and heading forward on the main frame drivers side is another small
> module that I have no idea what it is for. Then forwad of that ther is
> a larger module that I have no idea what it is for. Lots of fun. Does
> anyone out there have the superior knowledge to name the modules and
> their purpose. I feal like I am on a game show.
>
> Jim Hutchings
> 82 just like new 35RB
> Yorba Linda, CA
>
>