Swing Radiator in Texas

[Chuck Wheeler]

I modifies my radiator to swing about two years ago. It took about a week
working on and off after work. The way I did mine required three welds. I
cut the pieces, lined everything up, and a friend stopped by with his welder
and welded it up. I used one 1000lb gate hinge. If I need to remove the
radiator I can drain it, remove the hoses, and lift it off. (well two of us
can lift it off anyway!) I posted some pictures, but I think they
disappeared when the site splintered. If you are interested I will dig them
up. If you get to Fort Worth stop by and I will show it to you. It took
longer to correctly route the hoses and Hydraulic lines that to make the
radiator swing.

- Chuck Wheeler -
82 FC 31 SB
Fort Worth, TX


_____

From: WanderlodgeForum@yahoogroups.com
[mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of Henry F. Claeys
Sent: Tuesday, August 29, 2006 11:03 PM
To: WanderlodgeForum@yahoogroups.com
Subject: [WanderlodgeForum] Swing Radiator in Texas



(1) Where's the closest place to Austin, Texas that I can go to have a
swing radiator put on my 1979 FC 35? (2) Is there anyone that offers
mobile service, like Fullenwider, who would come to Austin to install
the swing radiator? (3) Is it possible to purchase the parts and have
them installed locally? If so, where can I purchase the parts? (4)
Any input/ideas appreciated. Thanks. Henry Claeys, Austin, Texas.
Cell, 1.888.745.1439; E-mail, henry@henryfclaeys.
com






[Non-text portions of this message have been removed]