dash generator start/stop switch wiring

[Gardner Yeaw]

Bill,
There was not an attachment? It may have been deleted by the board, can
you send it directly ( gcyeaw@... )

Thanks
Gardner
78FC33

-----Original Message-----
From: WanderlodgeForum@yahoogroups.com
[mailto:WanderlodgeForum@yahoogroups.com]On Behalf Of Wilhelmus Schreurs
Sent: Tuesday, September 05, 2006 11:45 AM
To: WanderlodgeForum@yahoogroups.com
Subject: Re: [WanderlodgeForum] Re: dash generator start/stop switch wiring

Gardner:
84 blueprint shows an 8 pin switch. attached you will find a schematic
drawing which is redrawn from the wiring diagram. Hope this helps.

Bill 84FC35SB
Terrace, B.C.

Gregory OConnor < Gregoryoc@... > wrote:
Glowplugs ???. is the extra side momentary? maybe the switch was a
after factory replacement???. I have a 110 light switch in one
dumptruck that runs the fan overide, not a ford item.

GregoryO'Connor
94ptRomoland--- In WanderlodgeForum@yahoogroups.com
, "Gardner Yeaw"
wrote:
>
> On my 78FC33 the gen start/stop switch would only stop the genset,
not
> start it. The wiring diagram shows a DPDT switch, one side used for
> start and the other used for stop. My kitches switch is wired that
way,
> but the dash switchis different. My dash switch is a DPDT with two
> extra lugs (8 connections in all). It seems that both the stop and
> start is run from one side of the DPDT. I moved the three
connections
> to the other side of the switch and now it works. So that solved
the
> imediate problem.
>
> What I don't understand is what are the other two connections?
There
> are wires connected, but I don't know where they go. Has anyone
seen
> this style switch or know the function of the extra lugs?
>
> Gardner
> 78FC33
>


---------------------------------
Share your photos with the people who matter at Yahoo! Canada Photos

[Non-text portions of this message have been removed]



[Non-text portions of this message have been removed]