replacement of water faucet.

[Leroy Eckert]

Dave:
I have not replaced the kitchen faucet but did retrofit my bath sink and
plumbing. I had to fabricate flared tubing on my installation because I moved
the sink location. You shouldn't have that problem.
Your drop-in kitchen sink should have 3 holes for the faucet fixture. If you
have a spray wand add a hole. If you have a hand soap dispenser add another
hole. I'm trying to visualize Insta Hot. If you have that system you'll need to
R/R the plumbing. I think mine is in the sink. Depending on your
configuration you should be able to purchase a new faucet at Home Depot or Ace
Hardware. Installation should be about one hour unless something is goofy with
the supply lines. Be sure to pressure test before closing up.

Second, repair kits are available for most faucets. If you are handy and the
faucet is leaking at the control you may be able to re-seal it.


Leroy Eckert
1990 WB-40
Niceville, FL





----- Original Message -----
From: David Heibult
To: WanderlodgeForum@yahoogroups.com
Sent: Wednesday, September 13, 2006 7:54 PM
Subject: [WanderlodgeForum] replacement of water faucet.


has any repace the kitchen faucet in a 1991 PT 40 .mine is leaking to
the point of not using. mine has a flexable hose that is covered with
S/S covering. I need to know what is the replacement p/n and how much
of a job to replaced. Dave 91 WLWB PT





[Non-text portions of this message have been removed]