hard to pull out paddles on grey and black water

[fwernlein]

Dupree/Miller will likey reply also...but I have had luck with: 1:
doing a good dump & flush. 2: then removing the two small recessed
screws and removing the paddles (this is why you flush well in
#1)...if the rubber seal looks good, just clean and lube (i use
silicone and avoid petro based for rubber) and reinstall, noting
which side faces in/outlet. If the seal is torn, hard or "wavy"
around the perimeter...order a new paddle.

Frank W.
85FC33
Woodbridge, VA.

--- In WanderlodgeForum@yahoogroups.com, "one_dusty_hoot"
wrote:
>
> Vaseoline??, or, KY Jelly??
> Bob Janes, Greenville, SC
>
> --- In WanderlodgeForum@yahoogroups.com, "Henry Jay Hannigan"
> wrote:
> >
> > Hey Jeff and others of interest.......
> > I am having a hard time pulling out the levers on my tanks...the
> twist
> > left is ok but it takes a ton to pull them out and a ton to put
> them
> > in the last 1/2 inch...and...I am getting olser......
> > been thinking about electrics....saw them at camping world for
$100
> > but they do not seem to be easy to install....I may just order
some
> > new paddles from Jeff mif this is the problem...I welcome
> suggestions.
> >
> > Thanks.
> > Regards,
> > Hank Hannigan
> > 90SP36
> > 80FC31
> > ps...paddle problem is on my 80FC31...the 90SP has new
> Dupree/Miller
> > air dumps.
> >
>