Bath electric heater
|
10-01-2006, 04:03
Post: #5
|
|||
|
|||
Bath electric heater
Jay,etal: I replaced the motor on the Fasco fan in the Galley on RUBY
(the long narrow one, also I think Fasco calls it the under cabinet or step), a while back. I got the motor from Grainger, I don't have the part # in my Maint log, but I am sure you can find one. Pull the heater and take the motor/fan and you can match it up. If you go that route, then you will have to buy a new fan as well, if I remember correctly, the shaft size was off. But no biggy there (cept another trip to Grainger) either, the hardest part was adjusting the fan so it did not hit anything. Works great. I prefer the electric heat when we can need to use it much quieter. Let me know if you have any problems I will (read have Judi) search for the invoice. ScottB 86FC35 "RUBY" 4 SALE Murrells Inlet SC "right next to heaven" --- In WanderlodgeForum@yahoogroups.com, "Jay Darst" wrote: > > Ernie, > was the heater a direct replacement? Fit same hole as the old one? > > Please tell me more! > > My bath heater works, makes heat, but then a safety "over-heat" switch > doesn't allow it to run again for about 30 minutes. Gets cool in the > bathroom before the heater runs again. May need a new fan motor. > > I'd like to replace it. Have not found the direct replacement yet. > > Thanks > Jay Darst > 85PT40 > Springfield, IL > > > > --- In WanderlodgeForum@yahoogroups.com, "Ernest Ekberg" > > > > > I removed and replaced my heater today. It still works and I just > > wanted something newer. It is available to anyone for free- just pay > > for postage. Ernie- 83PT40 in warm Montana > > > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Bath electric heater - Ernest Ekberg - 09-30-2006, 07:32
Bath electric heater - erniecarpet@... - 09-30-2006, 23:31
Bath electric heater - Jay Darst - 10-01-2006, 02:50
Bath electric heater - erniecarpet@... - 10-01-2006, 03:32
Bath electric heater - Scott - 10-01-2006 04:03
Bath electric heater - Terry Neal - 10-01-2006, 04:07
|
User(s) browsing this thread: 1 Guest(s)