Microwave/Convection Oven

[Bob Lawrence]

Hi Leroy,
Thanks for the reply...but..mine doesn't have any of that..I can see
4 feet but don't see any bolts thru the bottom of the stainless.
Looks like yours is a lot different than mine.
Bob
--- In WanderlodgeForum@yahoogroups.com, "Leroy Eckert"
wrote:
>
> Bob: My Sharp hangs above the stove in the overhead cabinet. The
original had 2 mount bolts on the top near the front of the unit
which required me to remove the tank monitor panel to access. These
bolts were installed through a horizontal wood plate. The new
installation had bolts from the lower front of the unit to the top
of the wall mount plate on a 45 degree angle. In both cases the
lower rear of the unit rested on a lip in the wall mount bracket
which allowed the unit to be rotated up to its final position. The
unit was placed on the lip at about 45 degrees and the front rotated
up. Reverse the order for removal. Note: The wall mount bracket
contained about 60 screws. I guess BB did not want it t move.
> Hope this helps.
>
> Leroy Eckert
> 1990 WB-40
> Niceville, FL
>
>
>
>
>
> ----- Original Message -----
> From: Bob Lawrence
> To: WanderlodgeForum@yahoogroups.com
> Sent: Tuesday, November 07, 2006 6:14 PM
> Subject: [WanderlodgeForum] Re: Microwave/Convection Oven
>
>
> Speaking of micros, last night mine died while wife was cooking
my
> turkey legs...we have an 84 PT36...the Sharp is mounted in its
own
> cabinet...what's holding it in? Can I just pull it out without
> damage to cabinet? Anybody done this to an 84?
> Bob Lawrence
> 84 PT36
> Tacoma, Wa.
> >
> > Leroy, The dimensions of the Sharp I removed are 24 5/8(w) x
15
> 3/4
> > (h) x 18 3/4 (d). I believe the model number was R8580A.
Thanks
> > for your help. Mike McMahan
> >
> >
> >
> ----- Original Message -----
> > > From: Mike McMahan
> > > To: WanderlodgeForum@yahoogroups.com
> > > Sent: Wednesday, November 01, 2006 5:51 PM
> > > Subject: [WanderlodgeForum] Microwave/Convection Oven
> > >
> > >
> > > Well the original Sharp Microwave/Convection Oven in my 1989
> > PT40
> > > finally died. It is a Model R8580A. I remember several of
you
> > have
> > > replaced yours and I was checking to see if any of you could
> > tell me
> > > what later model units would fit well in the built in space
in
> > the
> > > bird. I was told that a Sharp R930 was close but I wanted to
> > check
> > > with the group. Thanks, Mike McMahan 1989 PT Counting the
days
> > until
> > > leaving for South Padre Island for Christmas break
> > >
> >
>
>
>
>
>
> [Non-text portions of this message have been removed]
>