Shower Water Mixer Repair?

[Kevin Ford]

Scott the grease is a good tip, and I will make sure I include this
in the parts list.
Thanks!
Kevin

--- In WanderlodgeForum@yahoogroups.com, "Scott"
wrote:
>
> Bill, took the words right out of my "keyboard" :>) I did alll the
> valves in RUBY last fall, and they work great...
>
> Kevin, I would suggest you also get some "plumbers grease" to lube
> the o'rings inside. A tiny tube of "high temp, water proof" grease
> will work. I used Q tips to apply. Also on our 86FC I needed
> the "special wrench" (small plastice piece) came with the rebuild
> from HD to remove the existing core. Really easy job..
>
> Good Luck
>
> Scott B
> 86FC35 RUBY
> Murrells Inlet SC "leaving for OKC in the am"
>
> --- In WanderlodgeForum@yahoogroups.com, "pattypape"
> wrote:
> >
> >
> >
> > IF it is a Moen any HomeDepot,Lowe's or hardware store had the
> > replacement about $20.00. If you can wait Moen will sent it
free,
> just
> > call the 800 number.
> >
> > Bill 88 FC
> >
> > --- In WanderlodgeForum@yahoogroups.com, "Kevin Ford"
> wrote:
> > >
> > > Hello:
> > > My shower water mixer will no longer shut off on my 1982 PT40,
> and my
> > > questions is can this be repaired or do I have to replace it (I
> > assume
> > > it is orginal)? I'm hoping it can be repaired since it will
> be "very"
> > > difficult to remove without damaging the shower stall.
> > >
> > > As always your help is greatly appreciated!
> > >
> > > Kevin Ford
> > > 1982 PT-40, Richmond TX
> > >
> >
>