Satellite Receiver Hookup

[Tom Warner]

Jack the switch itself is very simple with two inputs , one from the
rear cable tv line coming from the same small compartment that the
shore line power receptacles are housed, the other from your rooftop
TV antenna. The output of the switch goes to the amplifiers etc and
then to each wall outlet for your tv, one near the passenger side
wall in front, one to the front backup/tv monitor and the other to
the rear bedroom.
I dont use the one from the rear cable tv input so removed the
connector from the switch and connected the new cable running from
the satellite receiver to it.

tom

At 05:32 PM 2/7/2007, you wrote:
>Tom a simple diagram would be great. I have had trouble with the BB
>switch to work with my sat. Set up.
>Thanks
>Jack Jones
>East Tn 87
>PT 40
>
>WanderlodgeForum@yahoogroups.com, Tom
>Warner wrote:
> >
> > In my 1985 PT 40 setup (was the same for my 1982 FC35) there is a
> > switch with two positions in the small upper bin that houses the
> > switch and amplifiers and two AC receptacles. One input to the
>switch
> > is from the outside cable TV input that is in the drivers side
>rear
> > compartment where the AC inputs are. The other input is from the
> > overhead TV antenna. I installed a new satellite antenna and ran
>the
> > two output cables and control cable from it thru a new cable
>entrance
> > I installed near the goat rail into the inside overhead bin. From
> > there the control cable goes directly to control switch for the
> > direct satellite control box, and one of the satellite antenna
> > outputs goes to the receiver, the other is left coiled up since I
> > dont use it. I ran a new coax from the output of the satellite
> > receiver to the 2 position switch provided by BB, disconnected the
> > input from the rear cable TV line and connected the output from
>the
> > satellite receiver in its place. Now I can chose either the
>overhead
> > TV antenna or the satellite receiver output. I also added a
>modulator
> > and DVD player and routed its output to the satellite receiver
> > external antenna input. Now with the satellite receiver on I can
>use
> > it, or when I switch it off can chose the DVD player. The
>satellite
> > receiver has an internal switch that switches the output from the
> > satellite receiver to the DVD player when it is switched off.
> >
> > Tom Warner
> > vernon center,ny
> > 1985 PT 40
> >
> > At 12:20 PM 2/7/2007, you wrote:
> > >That wouldn't be the first time Jim. Although, as I just replied
>to
> > >Tom, I did try going through the existing setup and had
> > >trouble. It's been awhile but I seem to recall a problem with
>the
> > >splitters behind the switch/amp box. Maybe I have a problem
>there
> > >and it just isn't showing up the way I using it now with only 1
>tv.
> > >
> > >Dick Hayden - '87 PT 38 - Lake Stevens, WA
> > >
> > >
> > > ----- Original Message -----
> > > From: jqrjr
> > > To:
> > >
>WanderlodgeForum@yahoogroups.com<mailto:W\
anderlodgeForum@yahoogroups.
>com>
> > > Sent: Wednesday, February 07, 2007 8:42 AM
> > > Subject: [WanderlodgeForum] Re: Satellite Receiver Hookup
> > >
> > >
> > > BY the way, I also think that Dick is wrong.
> > > Jim Riordan
> > >
> > > --- In
> > >
>WanderlodgeForum@yahoogroups.com<mailto:W\
anderlodgeForum@yahoogroups.
>com>,
> > > "Leroy Eckert"
> > > wrote:
> > > >
> > > > Well, I cannot tell you exactly how my coach is wired unless
>I go
> > > out and track down the wires. It took me and a video guy a
>while to
> > > get it right. Here is how mine works.
> > > > I have 3 TV's.
> > > >
> > > > I have:
> > > > In motion Satellite Receiver box(technical name escapes me
>at the
> > > moment) L-3 TracVision
> > > > A-B switch in the coach.
> > > > Land line cable port (factory)
> > > > Space Ship Air Antenna installed at factory.
> > > >
> > > > When my satellite receiver is on I receive satellite TV.
> > > > When I plug into cable TV, park supplied, and turn off the
> > > satellite receiver I receive cable TV.
> > > > If I want to use the Air antenna, seldom, I switch from A to
>B and
> > > I receive nearby stations over the air. Satellite TV receiver
>off.
> > > > In the satellite and cable configuration the switch is
>always in
> > > position A.
> > > >
> > > > Reception is very clear in all cases.
> > > >
> > > > I hope this helps you.
> > > >
> > > > Leroy Eckert
> > > > 1990 WB-40 "Smoke N Mirrors"
> > > > Niceville, FL
> > > >
> > > >
> > > >
> > > >
> > > >
> > > > ----- Original Message -----
> > > > From: what1not
> > > > To:
> > > WanderlodgeForum@yahoogroups.com >40yahoogroups.com>
> > > > Sent: Tuesday, February 06, 2007 7:52 PM
> > > > Subject: [WanderlodgeForum] Satellite Receiver Hookup
> > > >
> > > >
> > > > Hi Everyone,
> > > >
> > > > I have a '87 PT40 and I am looking at adding a portable
>satellite
> > > > dish to my setup.
> > > >
> > > > A couple of questions:
> > > >
> > > > 1. Can you bring the satellite signal through the cable input
> > > switch
> > > > to the satellite receiver?
> > > >
> > > > 2. I understand that there is power going to the dish from
>the
> > > > satellite receiver and that there is an issue with the
>amplifier
> > > for
> > > > the regular antenna which somehow do not allow the satellite
>and
> > > > reciever to properly communicate. If I can't go through the
>A C
> > > > switch in the coach can I split the cable input to the
>switch and
> > > > then go directly to the satellite receiver when not using a
>cable
> > > > setup?
> > > >
> > > > Any other info is greatly appreciated!
> > > >
> > > > Jo and Bill Neil
> > > > '87 PT40
> > > >
> > > >
> > > >
> > > >
> > > >
> > > > [Non-text portions of this message have been removed]
> > > >
> > >
> > >
> > >
> > >
> > >
> > >[Non-text portions of this message have been removed]
> > >
> > >
> > >
> > >
> > >Yahoo! Groups Links
> > >
> > >
> > >
> >
>
>
>
>
>
>Yahoo! Groups Links
>
>
>