Camera

[Leroy Eckert]

I am going to check the wires to the monitor tomorrow. I hope. Question? Does
it have a transformer that I should pay attention to so I do not get Zapped?

Leroy Eckert
1990 WB-40"Smoke N Mirrors"
Niceville, FL




----- Original Message -----
From: Ralph L. Fullenwider
To: WanderlodgeForum@yahoogroups.com
Sent: Sunday, February 11, 2007 5:46 PM
Subject: Re: [WanderlodgeForum] Re: Camera



>
Hi Leroy:

Check the back side of the monitor, there you should find a white connector
with several wires on it. It plugs onto the mother board. Those wires a
fragile and are notorious for breaking, there by being intermittent. Solder
each one after removing from the plug and re insert the pins then re
install to the mother board.

Something to try before trashing the system.

Ralph

Safe travels,

Ralph and Charolette Fullenwider (in SPI with a bad ride height valve and
water leak)
'84 FC35 Duncan, Oklahoma
Ralph's RV Solutions

> >
> > My camera is intermittant. When it works it has a shape picture.
> I
> > believe the potentiometer is going in the tank. I have contacted
> Tim
> > at RVcams and am awaiting a response.
> >
> > Info:
> >
> > Camera is Sanyo CCD Computar Wide Attack, Model VDC 3800
> > Tube is Clinton Tiawan Corp
> > Potentiometer is A-B Mod Pot PN 26M955. Cannot locate one even at a
> > guitar parts house to see if it is the problem- I'm told they are
> > unavailable. I'm about to give up and retrofit.
> >
> > I saw a post where someone retrofitted a system without rewiring
> the
> > bus. Any info would help. Good or Bad. Thanks.
> >
> > Leroy Eckert
> > 1990 WB-40 "Smoke N Mirrors"
> > Niceville, FL
> >
>
>





[Non-text portions of this message have been removed]