Frozen pipes

[ernieekberg@...>]

Would you have to have a bypass valve on this project?
Ernie Ekberg
83PT40
Livingston,Montana
----- Original Message -----
From: Terry Neal
To: WanderlodgeForum@yahoogroups.com
Sent: Sunday, February 18, 2007 11:10 AM
Subject: Re: [WanderlodgeForum] Frozen pipes


Just install the pump and then add a "crossover" from the hot to the
cold lines, probably put it under the galley sink since there is "some"
access there.

Terry Neal
Bozeman, MT
82PT40
74FC34

ernieekberg@... wrote:

> Will you have to make any modifications to allow the water to recirculate?
> Ernie Ekberg
> 83PT40
> Livingston,Montana
> ----- Original Message -----
> From: Terry Neal
> To: WanderlodgeForum@yahoogroups.com
>
> Sent: Sunday, February 18, 2007 10:53 AM
> Subject: Re: [WanderlodgeForum] Frozen pipes
>
> Same place mine froze too Ernie. Heat tape & PEX should fix it. I'm
> going to add the circulating pump to my system too. If it's moving, it
> won't freeze.
>
> Terry Neal
> Bozeman, MT
> 82PT40
> 74FC34
>
> Ernest Ekberg wrote:
>
> > I have found the weakest link to the frozen pipes saga. The water pipe
> > run through the nightstand on the street side have been repaired many
> > times due to the fact that there is no warm air circulating there.
> > So, this is the area that needs most of the attention. I will repair
> > all these runs with pex and add some heat tape.
> > Ernie-83PT40
> > Livingston, Mt
> >
> >
>
> [Non-text portions of this message have been removed]
>
>





[Non-text portions of this message have been removed]