Frozen pipes

[Terry Neal]

Maybe. Might not need one. Want to keep it as simple as possible & not
cause problems with regular system flows.

Terry Neal
Bozeman, MT
82PT40
74FC34



ernieekberg@... wrote:

> Would you have to have a bypass valve on this project?
> Ernie Ekberg
> 83PT40
> Livingston,Montana
> ----- Original Message -----
> From: Terry Neal
> To: WanderlodgeForum@yahoogroups.com
>
> Sent: Sunday, February 18, 2007 11:10 AM
> Subject: Re: [WanderlodgeForum] Frozen pipes
>
> Just install the pump and then add a "crossover" from the hot to the
> cold lines, probably put it under the galley sink since there is "some"
> access there.
>
> Terry Neal
> Bozeman, MT
> 82PT40
> 74FC34
>
> ernieekberg@... wrote:
>
> > Will you have to make any modifications to allow the water to
> recirculate?
> > Ernie Ekberg
> > 83PT40
> > Livingston,Montana
> > ----- Original Message -----
> > From: Terry Neal
> > To: WanderlodgeForum@yahoogroups.com
>
> >
> > Sent: Sunday, February 18, 2007 10:53 AM
> > Subject: Re: [WanderlodgeForum] Frozen pipes
> >
> > Same place mine froze too Ernie. Heat tape & PEX should fix it. I'm
> > going to add the circulating pump to my system too. If it's moving, it
> > won't freeze.
> >
> > Terry Neal
> > Bozeman, MT
> > 82PT40
> > 74FC34
> >
> > Ernest Ekberg wrote:
> >
> > > I have found the weakest link to the frozen pipes saga. The water pipe
> > > run through the nightstand on the street side have been repaired many
> > > times due to the fact that there is no warm air circulating there.
> > > So, this is the area that needs most of the attention. I will repair
> > > all these runs with pex and add some heat tape.
> > > Ernie-83PT40
> > > Livingston, Mt
> > >
> > >
> >
> > [Non-text portions of this message have been removed]
> >
> >
>
> [Non-text portions of this message have been removed]
>
>