How to clear codes?

[jqrjr]

If I remember correctly the tech at DD told me that all you need to
do is put in reverse and then in drive. If you turn off all 12 volt
power this should also clear.

Jim Riordan
88 WLWB XXV
Stuart, Fl.


--- In WanderlodgeForum@yahoogroups.com, "Steve & Kathy Enfinger"
wrote:
>
> Remember the problem I had with "check engine light" staying on ...
I
> found several corroded ground connections but the culprit turned
out to
> be the connectors to the DDEC II unit. Not visibly corroded but
first
> time I removed & then reconnected it fixed problem. I cleaned them
well
> & applied a dab of "corrosion block".
>
> Now I need to clear all those bogus diagnostic codes. Can it be
done
> without hooking into test instrument?
>
> Thanks,
>
> Steve & Kathy Enfinger
> 91 WBSA
> Newton, GA
>