Backup Camera Cables

[Tim Hannink]

If I were going out and buying cable for this, I would recommend an
RG-6 also, but since he has the RG-62 already, the run is under 50-
feet and he can pre-test it before installing it, I don't see any
problem with trying it. Worst case, it doesn't work and he has to go
buy some RG-59/6.

I have some extra RG-6 at home, I just ran two runs to the roof for
a satellite dish connection. Let me know if you need any.

Good luck,

Tim Hannink
Winter Park, FL
1981 FC-33SB

--- In WanderlodgeForum@yahoogroups.com, Tom Warner
wrote:
> Tim I would not use RG62 since it is a 93 ohm cable. You should
use RG6
> which is 75 ohms. Also make sure that the cable you buy has a good
inner
> braided shield to eliminate interference from getting on the cable.
>
> Tom
> 1982 FC35
> Vernon Center,NY
> In the beautiful Mohawk Valley
>
> At 03:20 PM 4/28/2005 +0000, you wrote:
> >The RG-62 with a standard BNC's should work, I would test it
before
> >installing it by doing a temporary connection with about 50-foot
of it
> >directly to the TV.
> >
> >You will also need an ignition-switched 12-volt signal wire.
> >
> >Good luck,
> >
> >Tim Hannink
> >Winter Park, FL
> >1981 FC-33SB
> >
> >--- In WanderlodgeForum@yahoogroups.com, "freewill2008"
> > wrote:
> > > I hafta pull some wires the length of our bus behind the
overheads
> >and
> > > would like to pull in what I need for a camera at the same
time.
> >(This
> > > bus didn't have a factory camera installed.)
> > >
> > > What kind of cabling do I need? I'm sitting on a bunch of
coaxial
> >RG62
> > > cable with BNC connectors. Is that impedance close enough for
a 35'
> > > run? Also, does the camera need a 12v power cable also?
> > >
> > > Thanks in advance.
> > >
> > > Bob Griesel '84 FC31 WLII WA
> >
> >
> >
> >
> >
> >----------
> >Yahoo! Groups Links
> > * To visit your group on the web, go to:
> > *
> >
<http://groups.yahoo.com/group/WanderlodgeForum/>http://groups.yahoo.
com/group/WanderlodgeForum/
> >
> > *
> > * To unsubscribe from this group, send an email to:
> > *
> > subject=Unsubscribe>WanderlodgeForum-unsubscribe@yahoogroups.com
> >
> > *
> > * Your use of Yahoo! Groups is subject to the
> > <http://docs.yahoo.com/info/terms/>Yahoo! Terms of Service.