RCA back-up camera

[James Harvie]

Keith, It's funny you ask this question. When I bought my FC 35 a few weeks ago
the back up moniter didn't work. It was midnight and snowing , and I had about
80 or so miles to go, so I didn't care at that time, what was behind me, lol,.
Anyway, a few days later, I tried it again and it worked, then yesterday it
didn't. Today I took the cover off, for the camera, and with the key on, I
watched the moniter, while I wiggled the camera. It lit up, I looked at the
coax, and it was jammed up against the vinyl ceiling panel, right where the end
connects, into the camera. I tugged on the end and it came apart. On mine,
there's a tiny slip collar with a rubber gasket inside, that collapes against
the cable, to keep it tight, when you tighten it. I slid it in and I placed the
ground outside along the connection, and secured it with a small fuel hose
clamp, it worked for me, Good luck.


Jimmy Harvie
"Howard O. Truitt" wrote: 82FC 35 Boston
Keith,
I pulled my back up camera out and checked the board for cracks in the soldering
and found a couple cracks.
Resoldered and put back in and still working fine.
Howard Truitt
Camilla, Ga.
86 PT40

----- Original Message -----
From: Keith Strehle
To: WanderlodgeForum@yahoogroups.com
Sent: Thursday, March 22, 2007 4:08 PM
Subject: [WanderlodgeForum] RCA back-up camera

I know there is power to the terminals but it does not work. So I want
to take my (original equipment?)RCA back-up camera out to have it
tested or to determine if it's worth fixing. Any suggestions?

Keith
84FC35
San Diego

[Non-text portions of this message have been removed]






---------------------------------
It's here! Your new message!
Get new email alerts with the free Yahoo! Toolbar.

[Non-text portions of this message have been removed]