headlamp assemblies

[joewalton2003]

Fred, they look very similar to mine, start at the bottom. Remove the
bumper, then the shroud above it. Open the generator compartment as far
as it will go, and you will see the mounting assembly. The corner light
and both headlights are mounted in one sub-assembly.



I sanded mine and re-polished them, but was only able to reduce the
yellowing by about 60-70%. Good luck



Joe Walton

1991 WB-PT40

Yuma, AZ

--- In WanderlodgeForum@yahoogroups.com, "Fred Hulse"
wrote:
>
> 97 WL PT41
>
> I am going to change the plastic headlamp assemblies because of
sand,and rock chip damage, along with yellowing that I can not clean up
successfully.
> I can see the body panel below and aside the lamps sem to be
removeable.
> Has anyone removed these lamp assemblies?
> Fred & Jeanne Hulse
> Morristown Arizona
> 1997 Wanderlodge WLWB41
>
> [Non-text portions of this message have been removed]
>



[Non-text portions of this message have been removed]