Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1992 WB40 Spare wire from front to back?
04-01-2007, 13:56
Post: #9
1992 WB40 Spare wire from front to back?
Michael, the toad needs a ground that is common
to the coach for the aux 12 volts, otherwise no
reference, no charging.
bob janes, 87fc35, greenville, sc

--- In WanderlodgeForum@yahoogroups.com, "mbrund" <mbrund@...> wrote:
>
> Well as luck would have it, I took the front nose panel off where
> all the relays and fuses are and I saw two wires that where in
> convoluted tubing and has a hand written label that said 'run to
> back' I jumped under the coach out back and sure enough there they
> where. I ohmed them to verify and sure enough. So some kind sole
> before me had already done the hard work Smile So I just need to hook
> it to the controller in the coach now.
>
> Also I needed to run 12 volt from the engine batteries to TOAD to
> charge the battery. I was having a hard time finding a wire in the
> engine bay that was only hot when the ignition was on so I could
put
> it to a relay so the wire to the toad battery is only hot when the
> coach ignition was on. Then I looked up and remembered the rear
> coach ignition box, so I removed the screws and determined that the
> center post on one side of the front/off/rear switch is hot only
> when the front or rear ignition switch is on. So I tapped into
that
> and ran it to the relay, so now I have a hot AUX going to the toad
> only when the ignition is on.
>
> --- In WanderlodgeForum@yahoogroups.com, "mbrund" <mbrund@> wrote:
> >
> > Is there a spare wire that runs from the front to the back of a
> 1992
> > WB40 that I can use for my brake controller?
> >
> > I have a US Gear D-Celerator brake system that needs one wire to
> tell
> > the system in the toad to apply the brake, and another to keep
the
> > battery charged. I am not worried about the one for charging as
I
> can
> > grab that right off the back of the coach, but did not want to
> have to
> > run a wire all the way from the front to the back if a spare
> already
> > exists for that.
> >
> > Michael Brundridge
> > 1992 WB40 - newbie
> > Georgetown, TX
> >
>
Quote this message in a reply
Post Reply 


Messages In This Thread
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 13:10
1992 WB40 Spare wire from front to back? - Leroy Eckert - 03-30-2007, 13:35
1992 WB40 Spare wire from front to back? - one_dusty_hoot - 03-30-2007, 15:08
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 15:40
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 16:01
1992 WB40 Spare wire from front to back? - Leroy Eckert - 03-30-2007, 16:36
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 13:05
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 13:11
1992 WB40 Spare wire from front to back? - one_dusty_hoot - 04-01-2007 13:56
1992 WB40 Spare wire from front to back? - mbulriss - 04-01-2007, 14:38
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 14:46
1992 WB40 Spare wire from front to back? - Leroy Eckert - 04-02-2007, 10:04



User(s) browsing this thread: 2 Guest(s)