Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1992 WB40 Spare wire from front to back?
04-01-2007, 14:38
Post: #10
1992 WB40 Spare wire from front to back?
Bob,

Isn't that what pin one is for on the standard RV plug wiring? To
provide a common ground?

Michael, there are pictures in the "Files" under 'RV Plug Wiring' that
show all the connections if you are in need of such a diagram.

Mike Bulriss
1991 WB40 "Texas Minivan"
San Antonio, TX




--- In WanderlodgeForum@yahoogroups.com, "one_dusty_hoot"
wrote:
>
> Michael, the toad needs a ground that is common
> to the coach for the aux 12 volts, otherwise no
> reference, no charging.
> bob janes, 87fc35, greenville, sc
>
> --- In WanderlodgeForum@yahoogroups.com, "mbrund" <mbrund@> wrote:
> >
> > Well as luck would have it, I took the front nose panel off where
> > all the relays and fuses are and I saw two wires that where in
> > convoluted tubing and has a hand written label that said 'run to
> > back' I jumped under the coach out back and sure enough there they
> > where. I ohmed them to verify and sure enough. So some kind sole
> > before me had already done the hard work Smile So I just need to hook
> > it to the controller in the coach now.
> >
> > Also I needed to run 12 volt from the engine batteries to TOAD to
> > charge the battery. I was having a hard time finding a wire in the
> > engine bay that was only hot when the ignition was on so I could
> put
> > it to a relay so the wire to the toad battery is only hot when the
> > coach ignition was on. Then I looked up and remembered the rear
> > coach ignition box, so I removed the screws and determined that the
> > center post on one side of the front/off/rear switch is hot only
> > when the front or rear ignition switch is on. So I tapped into
> that
> > and ran it to the relay, so now I have a hot AUX going to the toad
> > only when the ignition is on.
> >
> > --- In WanderlodgeForum@yahoogroups.com, "mbrund" <mbrund@> wrote:
> > >
> > > Is there a spare wire that runs from the front to the back of a
> > 1992
> > > WB40 that I can use for my brake controller?
> > >
> > > I have a US Gear D-Celerator brake system that needs one wire to
> > tell
> > > the system in the toad to apply the brake, and another to keep
> the
> > > battery charged. I am not worried about the one for charging as
> I
> > can
> > > grab that right off the back of the coach, but did not want to
> > have to
> > > run a wire all the way from the front to the back if a spare
> > already
> > > exists for that.
> > >
> > > Michael Brundridge
> > > 1992 WB40 - newbie
> > > Georgetown, TX
> > >
> >
>
Quote this message in a reply
Post Reply 


Messages In This Thread
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 13:10
1992 WB40 Spare wire from front to back? - Leroy Eckert - 03-30-2007, 13:35
1992 WB40 Spare wire from front to back? - one_dusty_hoot - 03-30-2007, 15:08
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 15:40
1992 WB40 Spare wire from front to back? - mbrund - 03-30-2007, 16:01
1992 WB40 Spare wire from front to back? - Leroy Eckert - 03-30-2007, 16:36
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 13:05
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 13:11
1992 WB40 Spare wire from front to back? - one_dusty_hoot - 04-01-2007, 13:56
1992 WB40 Spare wire from front to back? - mbulriss - 04-01-2007 14:38
1992 WB40 Spare wire from front to back? - mbrund - 04-01-2007, 14:46
1992 WB40 Spare wire from front to back? - Leroy Eckert - 04-02-2007, 10:04



User(s) browsing this thread: 1 Guest(s)