Power steering modifications 82 FC 35
|
04-08-2007, 07:28
Post: #2
|
|||
|
|||
Power steering modifications 82 FC 35
Drove it for the first time today since the modifications. When it tested it
prior to modifications the power steering reservoir was running around 220 degrees after the drive. Today it was 114 degrees, a huge improvement. The air temperature was about 35 degrees lower today than when I tested it prior to modification but the engine temperature was the same. So initially, the results are extremely promising. Keeping that fluid temperature down is better for the whole power steering system. Kerry 82 Fc 35 Denver --- In WanderlodgeForum@yahoogroups.com, "davidkerryedwards" wrote: > > I've almost completed some power steering modifications to my 82 FC 35. I've posted > some pictures in the photo section. It was leaking when I bought it and an examination of > the blue box shows it's had a long history of leaks throughout its life. The last person to > replace the suction hose used metal reinforced hose. Not a good idea since it is harder to > get a tight seal with a hoseclamp on that kind of hose. > I've added a new reservoir, a cooler and upgraded the hoses. I used high temperature > hoses. Aeroquip FC 332-10 rated for much higher temperature than the originals. I added > a new reservoir ($25 on Ebay) from same manufacturer as original. Twice the capacity, > vented top with dipstick plus a sight glass. The fittings are 1/2 pipe on the reservoir. On > the original which is still as it came from the factory as far as I know, the 1/2pipe was > bushed down to 3/8 with a 3/8 45 degree brass elbow at the outlet. This needlessly > restricted the flow thru the outlet. I went to 1/2 pipe for everything. I'd recommend that > even if you don't change the reservoir, when putting on new hoses, get rid of that bushing > and the 3/8 fittings. You want full flow as much as possible with no restrictions. Had to > move the reservoir slightly to the right to get it under the highest part of the doghouse. > > I added a cooler under the first compartment behind the left front wheel. My power > steering fluid was running way too hot (around 220 degrees) as measured with an infrared > thermometer. This is hard on everything. So I added the cooler to solve the problem. It > also helped me in rerouting the return hose which had previously run about 1 inch above > the exhaust portion of the aftermarket turbocharger. Very bad idea. Whoever installed > the turbo should have moved the hose. > I also sheathed the suction hose in firesleeve from the reservoir to the pump. The suction > hose runs right in the left frame rail a few inches from the exhaust manifold. Another less > than ideal situation. The firesleeve should reduce the amount of heat the fluid picks up on > the way to the pump. > Access to the return hose is through the floor under the steering wheel. Also, on mine, no > need to remove the battery tray for access from below. There is a sheet metal back to the > battery tray. Once this is removed, it is not hard to access the return line from below to > run a new one. You can see the return line on the outside of the outer frame rail thru the > battery compartment once the sheet metal back is removed. > I ran the return line back along the outer frame with the other wires/hoses to the cooler > and then from the cooler back on the inside of the inner frame rail to the reservoir. > Double clamped all hoses and used new barbs where I could. No way that I could find to > remove the barb on the pump. > I've got a slight leak at a fitting at the cooler so I need to remove the hose and retighten it > but everthing else seems fine. Had been sitting unstarted since October since I had > everything apart and couldn't do anything while the Bird was surrounded by snowdrifts. > Started on 1st compression stroke once I got it back together yesterday. > Power steering seems much better, less noise. I used synthetic blend power steering fluid > when I put it back together. I think the restriction in the line from the bushing may have > been starving the pump perhaps. > I'll let you know if everything works well once I get some miles on it. > > Kerry > 82 Fc 35 Denver > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Power steering modifications 82 FC 35 - davidkerryedwards - 03-17-2007, 08:19
Power steering modifications 82 FC 35 - davidkerryedwards - 04-08-2007 07:28
|
User(s) browsing this thread: 2 Guest(s)