Aqua Magic Toilet

[Ralph L. Fullenwider]

Keith:

You will need a long blade screwdriver, a long 3/8 drive extension, 1/2
socket and open end wrench.

Turn off the water, press down the foot pedal and use the screw driver to
hold it in place, that should allow you to get to the front nut.

with the seat up, there is a removable plug on the left side near the rear,
remove the plug, then useing the extension and socket you can remove the
rear nut. up inside there is the input water hose with a clamp, remove the
clamp and hose and that should allow you to pull the unit straight up.

Sounds like the vacuum breaker is leaking, I would replace both the vacuum
breaker and the inlet water valve, then re install.

Safe travels,

Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma

At 04:06 PM 4/12/2007 +0000, you wrote:
>Can anyone tell me how to get at the mounting bolts on an older Aqua
>Magic toilet? It's in very good condition but leaks from the back when
>flushing.
>
>Should I upgrade?
>
>Keith
>84FC35
>
>