Microphor toilet and variable speed pump

[mbulriss]

> Pete Masterson
> '95 Blue Bird Wanderlodge WBDA 42
> Currently in Amarillo TX -- heading south out of winter's last gasp...

So Pete,.... are you going to join us in San Antonio at the Lone Star
Birds Rally this weekend? We are definitely south of Amarillo! And warm.


Mike Bulriss
1991 WB40 "Texas Minivan"
San Antonio, TX





--- In WanderlodgeForum@yahoogroups.com, Pete Masterson
wrote:
>
> My original post was about _water_ pressure. But the air pressure
> issue is also an excellent point. As it happens, I have a Microphor
> 12v compressor that's independent from the coach air system. It's
> limited to 90 psi. I plan to move my dump valves over to the
> Microphor compressor when time allows as it will eliminate needing to
> 'air up' to dump.
>
> I notice that the air-dump valves seem to work ok with about 70 psi
> but are a little sluggish with less -- but I was in a very cold place
> when I was taking note of the pressures (I'd pumped up the coach with
> an external compressor since it wasn't worth the difficulty in
> starting the engine in 25 degree weather...)
>
> Pete Masterson
> '95 Blue Bird Wanderlodge WBDA 42
> Currently in Amarillo TX -- heading south out of winter's last gasp...
> aeonix1@...
>
>
>
> On Apr 12, 2007, at 11:29 AM, Richard Hayden wrote:
>
> > Along with air regulators for the Microphor we all should put them
> > on the air line to the dump valves. According to Randy it would
> > extend the valves life by not pushing so hard when running with the
> > air pressure is over 100 lbs. Just another project I haven't
> > gotten around too yet.
> >
> > Dick Hayden - '87 PT 38 - Lake Stevens, WA
> >
> > ----- Original Message -----
> > From: Pete Masterson
> > To:
> > WanderlodgeForum@yahoogroups.com > > om>
> > Sent: Wednesday, April 11, 2007 7:37 PM
> > Subject: Re: [WanderlodgeForum] Microphor toilet and variable
> > speed pump
> >
> >
> > Yes, I have the air-operated Microphor (with a small 12v compressor
> > in the basement compartment nearby). It would be worthwhile to check
> > the Microphor website for the installation/troubleshooting manual
> > for
> > your model.
> <snip>
>