Alt Fault flashing and solenoid clicking

[mbrund]

Shortly after starting my WB I get a Alt fault, the person I
purchased from said it has always done this. However, just in the
last week I get the fault and relays 9 and 9A in the lower
distribution panel which are the ALT1 and ALT2 selection relays
start clicking. Also a relay, which I am not sure what it is for
which is located in the engine compartment mounted on the curb side
at the firewall where all the shunts are located starts clicking as
well. This relay in the engine compartment looks like a starter
relay, it appears to be a large high power relay.

In my troubleshooting, I disconnected both relay 9 and 9A at the
forward lower distro panel and the rear relay continues to click.
Has anyone seen this issue? Is it an alternator issue, a relay
issue, or just a ground issue?

I see one alternator in my coach, most seem to call the this lower.
It is mounted under the A/C compressor. I have seen statements
about the other one being below the bed. Is this at rear of the
engine compartment, or the front? How do I get to it, meaning, what
do I need to do in the bedroom to get to it?

My Service Parts list in the blue box shows Delco #1117920 (160 AMP)
alternator installed, but not how many.

Michael Brundridge
1992 WB40
Georgetown, TX