Aquahot PM and start/stop of new pump
|
05-02-2007, 01:27
Post: #2
|
|||
|
|||
Aquahot PM and start/stop of new pump
Thanks for the tip Ralph, I'll definitely look into it.
David Brady '02 LXi, Smokey NC Ralph L. Fullenwider wrote: > > Good morning everyone: > > Earlier this year I had an Aquahot hot water problem on a '95 Bird. Low > flow was the symptom. I shut off the incoming cold water source, drained > the hot water side and took the hot water input and output fittings > apart. > Then using an old Par pump, I pumped in 1 gallon of vinegar until it > started to flow out of the output side then shut the out put valve off > while still pumping and let the Par pump shut off at it's 40 psi > point, un > plugged the Par pump and walked away form about 5 hours leaving the > vinegar > to sit static. > > Returning to the Aquahot after 5 hours, I put the output hose into a > container, ran a cold water source to the input side and started the pump > and opening the valves. The solution coming out was blue/green in > color. I > completely flushed the system with fresh water until the color of the > water > was clear. Then hooked the lines back up and started the water running in > the coach. No more lack of flow problem. > > This procedure should be added to the yearly PM schedule. The Aquahot hot > water is an heat on demand system and the 3/8 copper tubing wrapped > around > the heat source will scale and start to plug the anti scald valve. > > This may also have something to do with a present problem with the 5.7gpm > 65 psi pump run/stop/run/stop. I noticed this happening on the one I > installed in my coach and I found that I had a slight blockage on the out > put side. When I found that problem and repaired it, I had no more > problem. > Just some thoughts on that. > > Safe travels, > > Ralph and Charolette Fullenwider > 84FC35 > Ralph's RV Solutions, Duncan, Oklahoma > > > ------------------------------------------------------------------------ > > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.467 / Virus Database: 269.6.2/784 - Release Date: 5/1/2007 2:57 PM > [Non-text portions of this message have been removed] |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Aquahot PM and start/stop of new pump - Ralph L. Fullenwider - 05-02-2007, 01:10
Aquahot PM and start/stop of new pump - David Brady - 05-02-2007 01:27
Aquahot PM and start/stop of new pump - Wallace Craig - 05-02-2007, 02:15
Aquahot PM and start/stop of new pump - Ralph L. Fullenwider - 05-02-2007, 02:29
|
User(s) browsing this thread: 1 Guest(s)