Installing new guage.

[jim riordan]

Extension 222

Jim Riordan
88 WBWL XXV
Stuartr, Fl.

Rob Robinson wrote:
Thanks Bob. Much appreciated

On 12/05/07, bloomas wrote:
>
>
> ----- Original Message -----
> From: Rob Robinson
> To: WanderlodgeForum@yahoogroups.com
> Sent: Saturday, May 12, 2007 2:43 PM
> Subject: Re: [WanderlodgeForum] Re: Installing new
> guage.
>
> # for Teleflex
>
> 941 907 1000
> Bob Loomas 1985 PT 36
>
> Jim could you post that phone number for Teleflex
>
> On 12/05/07, jim riordan > wrote:
> >
> > Thanks,
> >
> > The new guage is not a 54438 Earl said the did not maske it anymore. He
> > sent me a "superseded" one the index numbers were different. He sent me
> a
> > new sensor it was for the old type guage it was reading 40% high. I
> called
> > Teleflex spoke to Joe Federsal (great help) he sent me the correct
> sensor
> > for the guage that I got from earl, everything seems to work now. This
> new
> > guage 9153278 is improved in that it first register point is at 140
> rather
> > than 100, top is 320 like the old one. the end result is that the gauge
> will
> > provide more accurate readings in the operational range than the old
> one. I
> > hope!
> >
> > Jim RIordan
> > 88 WBWL XXV
> > Stuart, Fl.
> > pattypape > l.com>> wrote:
> >
> >
> > Jim,
> >
> > I replaced both oil temp gages on our 88 FC ( 3208 oil and rear axle
> > temps) BB gage part number 54438, It is a Teleflex gage.
> >
> > If this is your gage the temp sensor is a Stewart-Warner, part
> > number 280EEF . It is available at truck parts stores. It has
> > several threaded bushings for all thread sizes, One will match the
> > original threads. BB did not have the correct sensor.
> >
> > Bill 88 FC Michigan
> >
> > --- In
WanderlodgeForum@yahoogroups.com Forum%40yahoogroups.com>,
>
> > jim riordan
> > wrote:
> > >
> > > I have just replace my oil temp guage. I got it from BB and it is
> > indexed differently from the original one. I needed to get a new temp
> > sending switch also...
> > >
> > > Jim Riordan
> > > 88 WBWL XXV
> > > Stuart, Fl.
> > >
> > > "Ralph L. Fullenwider" wrote:
> > > Hi Art:
> > >
> > > **CAUTION** **CAUTION**
> > >
> > > Remove the 4 bottom out side covers of the lower dash. If the lower
> > dash
> > > has been out before then it should lift up from the front edge and
> > slip
> > > forward a little. If it has not been out before then on the left
> > side of
> > > the lower dash, under one of the blank covers, will be a screw that
> > has to
> > > come out.
> > >
> > > Now, with the lower dash panel slid forward, remove the cb mic from
> > the
> > > holder and take the long screw out that holds the cb mic holder.
> > Now the
> > > upper lower dash should be free on that side and if it has been
> > removed it
> > > will probably be free to tilt forward. If it has not been out
> > before then
> > > you need a looooong phillips screwdriver, hold the right side of
> > the upper
> > > lower dash out and reach in with the long phillips and un screw the
> > far
> > > left L bracket. In the bottom center of the upper lower dash, after
> > the
> > > lower panel is moved forward you should see a screw that needs to
> > come out
> > > as well. Now your upper lower dash panel should be free to tilt
> > forward.
> > > **CAUTION** Do NOT force it, if it won't come out enough to replace
> > the
> > > gauge, find what is holding it. I cannot stress **CAUTION** enough
> > on this.
> > >
> > > While your in there, remove the light sockets with the lamps from
> > the other
> > > gauges and clean or replace them.
> > >
> > > Your going to find a "rats nest" of wiring under and behind both
> > panels.
> > > Remember if you drill, spindle or pierce any of those panels, they
> > are shot
> > > and cannot be brought back. Use only holes provided for screws and
> > such.
> > >
> > > Good luck
> > >
> > > Safe travels,
> > >
> > > Ralph and Charolette Fullenwider
> > > 84FC35
> > > Ralph's RV Solutions, Duncan, Oklahoma
> > >
> > > At 06:44 PM 5/10/2007 +0000, you wrote:
> > > >I have recieved a new engine oil temp guage from the fellow I
> > bought
> > > >my coach from. Now to install it. The guage is on the verticle
> > part of
> > > >the dash panel.Has anyone been into that panel? Any advise will be
> > > >better than me going in there blind!
> > > >
> > > >
> > > >Art Weatherly
> > > >Riverside Ca.
> > > >'85 PT36
> > > >
> > > >
> > > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > ---------------------------------
> > > Moody friends. Drama queens. Your life? Nope! - their life, your
> > story.
> > > Play Sims Stories at Yahoo! Games.
> > >
> > > [Non-text portions of this message have been removed]
> > >
> >
> > ---------------------------------
> > Be a PS3 game guru.
> > Get your game face on with the latest PS3 news and previews at Yahoo!
> > Games.
> >
> > [Non-text portions of this message have been removed]
> >
> >
> >
>
> --
> Rob, Sue & Merlin Robinson
> 94 WLWB
>
> [Non-text portions of this message have been removed]
>
> [Non-text portions of this message have been removed]
>
>
>

--
Rob, Sue & Merlin Robinson
94 WLWB

[Non-text portions of this message have been removed]






---------------------------------
Sick sense of humor? Visit Yahoo! TV's Comedy with an Edge to see what's on,
when.

[Non-text portions of this message have been removed]