Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
tach drive
05-03-2005, 12:07
Post: #4
tach drive
I am near Missoula, MT. The DD dealer here could not provide any
assistance, and Earl at BB was at a lose.

thanks a bunch




--- In WanderlodgeForum@yahoogroups.com, "Jeff Miller"
wrote:
> I believe that George is on the right track. If they are the
senders
> with one end capped (cable in/out), I have used vehicle speed
> sensor/senders I raided out of Prince On Board Computers, they were
> also used as cruise-control speed sensors.
>
> Otherwise there is always the old BlueBird parts department, ...
>
> - Jeff Miller
> http://www.wanderlodge.net
> http://www.millercoachworks.com
>
>
> --- In WanderlodgeForum@yahoogroups.com, George Lowry
> wrote:
> > Since you did not give your location, it is hard to be specific,
> > however, any Detroit dealer/distributor should be able to fulfill
> your
> > need. Also Most speedometer shops carry all kinds of
> instrumentation
> > and related senders. I have usually found them to be the most
> > economical.
> >
> > George Lowry
> > '95 WBDA 4203 & GM 4106 (for sale)
> > Spearfish, SD
> >
> > Vaughn Paul wrote:
> >
> > > Hi. Does anyone know the brand and where I might be able to
> purchase
> > > the tach generator on a DD 6V92. It looks like a mushroom with
2
> wires
> > > and is located on the engine near the valve covers
> > >
> > > Thanks a bunch
> > >
> > > Vaughn
> > > 1982 PT40
> > >
> > >
> > >
> > >
> > >
> > >
> > > Yahoo! Groups Links
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
Quote this message in a reply
Post Reply 


Messages In This Thread
tach drive - Vaughn Paul - 05-03-2005, 11:18
tach drive - George Lowry - 05-03-2005, 11:31
tach drive - Jeff Miller - 05-03-2005, 12:01
tach drive - Vaughn Paul - 05-03-2005 12:07
tach drive - Jay Darst - 05-03-2005, 12:19
tach drive - Vaughn Paul - 05-03-2005, 12:47
tach drive - Jay Darst - 05-03-2005, 13:01
tach drive - Jeff Miller - 05-03-2005, 13:24
tach drive - bus2nut - 05-03-2005, 17:49



User(s) browsing this thread: 3 Guest(s)