Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tachometer doesn't work
06-01-2007, 02:59
Post: #2
Tachometer doesn't work
Hi Ryan, personally I would want to be absolutely positive that these
wires are good all the way back to the other end. After you find out
where they go then you could run a continuity check or in this case a
non-continuity. If the insulation is melted off, there had to be a
problem, maybe the old tach, maybe not, maybe to much current running
through them, if that is the case they could be melted in other spots.
I would think that if a wire had gone to ground then there would have
been a short that would have taken out the fuse or breaker. Do the
wires themselves look burnt? A lot of times when there is too much
current, the copper strands will be burnt, if that is the case, the
wire is bad.
Marty
95 BMC 37
Kennewick Wa.
Quote this message in a reply
Post Reply 


Messages In This Thread
Tachometer doesn't work - Ryan Wright - 05-31-2007, 17:45
Tachometer doesn't work - martingregg598 - 06-01-2007 02:59
Tachometer doesn't work - Ryan Wright - 06-02-2007, 09:31
Tachometer doesn't work - Leroy Eckert - 06-02-2007, 09:42
Tachometer doesn't work - Art Weatherly - 06-03-2007, 13:47
Tachometer doesn't work - Ryan Wright - 06-03-2007, 13:59
Tachometer doesn't work - bloomas - 06-03-2007, 16:11
Tachometer doesn't work - Art Weatherly - 06-03-2007, 17:32



User(s) browsing this thread: 1 Guest(s)