Microwave

[Ralph L. Fullenwider]

Phil:

To start, remove the stove top cover, then remove the 12 vdc light, you
will have to cut the wires one at a time and tape over the ends as they
will be hot. The trim around the edges must be removed. Then remove the
screws that hold the stainless splash panels at the rear of the stove area.
The upper stainless cover should try to drop down with the trim removed.
Under each leg of the microwave are screws that hold it in place. Locate
the electrical cord and un plug it.

Now the old unit should be ready to slide out. You really need 2 people to
remove it from the cabinet, that puppy is heavy.

Measure the depth then check the specs on the 930AK.

Good luck

Safe travels,

Ralph and Charolette Fullenwider
'84 FC35
Duncan, Oklahoma


At 03:40 PM 6/4/2007 +0000, you wrote:
>I need to replace the microwave in my coach, the original one finally
>died after 24 years of use. Are there any special tricks for removing
>the old one? Doesn't seem to be anything mounting it down, but I can't
>get it to pull out. Also, anyone have a recommendation for a new
>convection microwave that will fit? Someone on the forum mentioned in
>an old post the Sharp R930AK that seems like the same height and width
>as the original, but is it too deep?
>
>Phil Olson
>Appleton, WI
>83FC35SB
>
>