Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Water Fill Value Problem (PT-40)
06-10-2007, 06:55
Post: #9
Water Fill Value Problem (PT-40)
Kevin,

Have you looked in the files section of the forum at document named
Sporlan Valve 30-11.pdf ? It describes the Sporlan Valve parts,
sequence of operation and lists common causes of failures.

FWIW,
Mike Bulriss
1991 WB40 "Texas Minivan"
San Antonio, TX



--- In WanderlodgeForum@yahoogroups.com, "Kevin Ford" wrote:
>
> I found the valve and removed the diaphram and cleaned it up as Curt
> described, but still no affect. I did check the voltage from the
> outside switch -- it is good. I need some value 101. It appears that
> the voltage is applied to fill the tank, but I don't understand how
> this valve directs the water flow, and with no voltage (switch in off
> position) what should happen? And any other ideas?
>
> Again thanks.
> Kevin
> Richmond TX
> '82 PT-40
>
>
> --- In WanderlodgeForum@yahoogroups.com, Curt Sprenger
> wrote:
> >
> > Kevin,
> >
> > I've experience the same issue. Sounds like the Sporlan Valve,
> located
> > near the water tank. The valve is controlled by the "fill tank"
> switch.
> > Our coach has the walk-around bed, water tank is under the bed, the
> > sporlan valve is on the drivers side of the water tank.
> >
> > Remove the four screws around the electro-magnet. Remove the rubber
> > diaphragm. Using a screw driver, stuff a small rag into the opening
> to
> > stop the water flow. Clean out any foreign matter, usually white
> stuff.
> > Carefully remove any foreign matter from the diaphragm. Reassemble
> and
> > all should be good.
> >
> > One small piece of crud will stop these valves from working.
> >
> > About a 20 minute project.
> >
> > Curt Sprenger
> > 1987 PT38 8V92 "MacAttack Racing"
> > Anaheim Hills, Calif.
> >
> >
> >
> > Kevin Ford wrote:
> >
> > > All:
> > > Need help with water fill valve on a 1982 PT-40. When I filled
> the tank
> > > yesterday the valve is now stuck in the "Fill Tank" position. I
> other
> > > words with the city water supplied, it keep overflowing and the
> onboard
> > > water pump will not presurize. Can someone tell me where the
> valve is
> > > located and any other troubleshooting tips would be appreciated.
> > >
> > > Kevin Ford
> > > Richmond TX
> > > 1982 PT-40
> > >
> > >
> >
>
Quote this message in a reply
Post Reply 


Messages In This Thread
Water Fill Value Problem (PT-40) - erniecarpet@... - 06-10-2007, 02:40
Water Fill Value Problem (PT-40) - Kevin Ford - 06-10-2007, 04:04
Water Fill Value Problem (PT-40) - Leroy Eckert - 06-10-2007, 04:20
Water Fill Value Problem (PT-40) - Curt Sprenger - 06-10-2007, 04:24
Water Fill Value Problem (PT-40) - Kevin Ford - 06-10-2007, 04:34
Water Fill Value Problem (PT-40) - Pete Masterson - 06-10-2007, 04:40
Water Fill Value Problem (PT-40) - Kevin Ford - 06-10-2007, 06:14
Water Fill Value Problem (PT-40) - pattypape - 06-10-2007, 06:37
Water Fill Value Problem (PT-40) - mbulriss - 06-10-2007 06:55
Water Fill Value Problem (PT-40) - Kevin Ford - 06-10-2007, 07:16



User(s) browsing this thread: 1 Guest(s)