Additional Engine Cooling System

[Curt Sprenger]

Ken,
Thank you for offering here. Much appreciated.

Ours measures 39-3/4" (top inside frame to bottom inside frame), plus
the 1-1/2" top and bottom lip, for a total of 42-3/4". It would have to
be 6" wide. There are 5 screws in the vertical (rear).

These are the flat measurements, no allowance for nice rounded corners,
but that can come out of the 39-3/4".

Thanks,

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, Calif.



erniecarpet@... wrote:

> Ken, on my PT, there would have to be a 39" tall by 4" wide. I have 3
> screws
> on the vertical and 1 each on the top and bottom that could hold the
> scoop
> in place without having to drill additional holes. I can't draw this out.
>
> Ernie Ekberg
> 83PT40
> Livingston, Mt
>
> ************************************** See what's free at
> http://www.aol.com. <http://www.aol.com.>
>
> [Non-text portions of this message have been removed]
>
>