Can Anyone Help??? Stuck with an extended generator... 84PT40!!!!

[mbulriss]

Don,

The hydraulic rams operate via an in/out toggle switch in the driver's
side front outside compartment on a PT, same place as the electric
controlled ram on my 91. The genset hydraulic rams run off the same
pump system as the HWH jacks.

Mike Bulriss
1991 WB40 "Texas Minivan"
San Antonio, TX

--- In WanderlodgeForum@yahoogroups.com, "Don Bradner"
wrote:
>
> What I wasn't clear about, and still am not, is "how/where do you
activate the ram on the hydraulic system?"
>
> On 6/30/2007 at 4:51 PM mbulriss wrote:
>
> >The safety latch on the hydraulic genset tray systems is a slide bar
> >locking assembly controlled manually by a bar handle sticking out the
> >front of the tray, which you push one way or the other to lock/unlock.
> > When locked, the bar ends then stick through holes in the frame
> >rails. There is a switch sensor that is activated when the bar is
> >locked in place. If not locked in place, a warning light on the dash
> >turns on.
> >
> >Sounds like BB went to the electric ram sometime in 1986, that did not
> >need the slide bar lock, based on recent posts.
> >
> >Mike Bulriss
> >1991 WB40 "Texas Minivan"
> >San Antonio, TX
>