Leveling system solenoid

[truitt44@...>]

Scott,
you should be able to find stamped on the end caps the model # and make. You
will probably have to do a good cleaning first. On one of mine the stamp was
faint but could read with a good light and magnifying glass.
Howard T., Sowega, 86 PT40


>
> From: "Scott Forman" <sforman@...>
> Date: 2007/07/04 Wed PM 05:18:09 EDT
> To: WanderlodgeForum@yahoogroups.com
> Subject: [WanderlodgeForum] Re: Leveling system solenoid
>
> Yes, I will call them if I have to, but wondered if it was more
> common item I might find at a place like NAPA. Lots of old cars use
> solenoids that LOOK similar....
>
> Scott
>
> --- In WanderlodgeForum@yahoogroups.com, "p_a_lazar"
> wrote:
> >
> > Scott,
> >
> > I hate being the master of the obvious Just call HWH. Just had my
> > solenoids replaced while there. They look like starter solenoids,
> but
> > I believe a bit different.
> >
> > Paul
> > 97wb43
> >
> >
> > --- In WanderlodgeForum@yahoogroups.com, "Scott Forman" <sforman@>
> > wrote:
> > >
> > > I am troubleshooting my inoperative levelers, and I think I have
> > > identified the culprit in one of the three-pin solenoids mounted
> under
> > > the step well. When I jump the current cross the solenoid, the
> motor
> > > runs, so I am pretty sure this is the problem. It is the one
> where the
> > > third pin must be grounded to deliver the current. Where can I
> find
> > > one of these?
> > >
> > > I bought a generic solenoid that looks similar, but it isn't
> getting
> > > the job done.
> > >
> > > Thanks
> > > Scott Forman
> > > 86 PT38
> > > Memphis
> > >
> >
>
>
>
>