Hot Feet!

[Chuck Wheeler]

I think that you are probably on to my problem Jim! I drove it far enough
to get warmed up and then set the idle up with the fan engaged. I could
feel warm air moving. I have some work to do!



- Chuck Wheeler -

82 FC 31 SB

Fort Worth, TX

_____

From: WanderlodgeForum@yahoogroups.com
[mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of James Hutchings
Sent: Tuesday, July 10, 2007 5:20 PM
To: WanderlodgeForum@yahoogroups.com
Subject: RE: [WanderlodgeForum] Re: Hot Feet!



I had the same problem, you have to have real good seals at every point of
the dog house to stop leaks when a window is open. I used high heat tape.
To seal where the doghouse meets the fire wall. That was the largest leak.
I also added sound / heat insulation to the are right of the throttle pedal
to stop radiant heat from the radiator. With 60 mph + wind on the nose and
any window open, the smallest opening lets a lot of heat through.

Jim

From: WanderlodgeForum@
yahoogroups.com
[mailto:WanderlodgeForum@
yahoogroups.com] On Behalf Of Chuck Wheeler
Sent: Tuesday, July 10, 2007 8:41 AM
To: WanderlodgeForum@
yahoogroups.com
Subject: RE: [WanderlodgeForum] Re: Hot Feet!

Actually I opened it to cool my feet and that helped some. The only thing
different was we couldn't run the generator so we had the windows and vents
open. This may have been drawing hot engine air in. It was much worse when
the radiator fan came on so it is hot air leaking from the engine someplace.

- Chuck Wheeler -

82 FC 31 SB

Fort Worth, TX

_____

From: WanderlodgeForum@
yahoogroups.com

[mailto:WanderlodgeForum@
yahoogroups.com
] On Behalf Of Jon
Sent: Tuesday, July 10, 2007 10:20 AM
To: WanderlodgeForum@
yahoogroups.com

Subject: [WanderlodgeForum] Re: Hot Feet!

--- In WanderlodgeForum@
yahoogroups.com, "Chuck Wheeler"
wrote:
>
> I am getting warm (Hot) air around my feet in the drivers area of
our FC. I
> have tries to check the obvious areas, Dog house seals etc. It's
not coming
> from the heaters. Has anyone else run into this? Is there
something I am
> overlooking? Any Ideas appreciated.
>
>
>
> - Chuck Wheeler -
>
> 82 FC 31 SB
>
> Fort Worth, TX

Did you close your vent up front? Kind of silly but it can happen.
>
> _____
>
> From: WanderlodgeForum@
yahoogroups.com
> [mailto:WanderlodgeForum@
yahoogroups.com] On Behalf Of pattypape
> Sent: Tuesday, July 10, 2007 5:54 AM
> To: WanderlodgeForum@
yahoogroups.com
> Subject: [WanderlodgeForum] Re: seat and shoulder belts
>
>
>
>
>
> Try this School Bus parts place.
>
> http://www.schoolbu
>
<http://www.schoolbu
<http://www.schoolbu
<http://www.schoolbuspartsco.com/WebPages...tbelts.htm>
spartsco.com/WebPages/safetyproducts/seatbelts.htm>
spartsco.com/WebPages/safetyproducts/seatbelts.htm
l>
> spartsco.com/WebPages/safetyproducts/seatbelts.html
>
> Bill 88 FC Michigan
>
> --- In WanderlodgeForum@
> yahoogroups.com, "bubblerboy64"
> wrote:
> >
> > My 1973 has had all the belts removed. I'd like to install
> shoulder
> > and lap belts. Found a location online selling belts brackets
etc.
> > Any one with experience on this perhaps you would give me some
> basic
> > instructions. I am mostly concerned about the anchor point for
the
> > shoulder part of the install. I assume that the floor area is
> pretty
> > straight forward. I am hoping that I can find and use the
original
> > anchor points on the floor. Area has been re carpeted but
> hopefully
> > I can locate and use them. I told you guys I'd have lots of
> > questions. Its going well however for me and I am really enjoying
> > the process.
> >
> > John Heckman
> > Central Pa
> > 1973 FC
> >
>
>
>
>
>
> [Non-text portions of this message have been removed]
>

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]





[Non-text portions of this message have been removed]