Threaded Mode | Linear Mode

08-13-2007, 01:38

My Kwikee Step has landed and I bolted them up to the bus yesterday and
started to review the wiring diagram. I believe I have some
understanding but were do I go to get a connection which is hot only
when the ignition is on? I would assume there is a fuse box some place
perhaps under the dash. I haven't come across it. I have one wire
which is hot all the time which I guess can go directly to the battery
with a fuse inline and then one to the ignition. I obviously don't
know a lot about vehicle electrics so some basic information needed.
Thanks again in advance. This is likely my last major improvement at
least in the short term.

John Heckman
Central Pa
73 FC (converted to Cat diesel)