Help with generator problem, AC voltage

[awojteczko]

Hi Jeff,

I assume the transfer switch is the OFF, GEN, 50, 30 position switch
by the entrance step. I have cycled this switch a number of times.
The previous owner has installed a plate with sound deadner on it
between the engine bell housing and generator assy. I have not
figured out how to remove this plate to get access to the generator.
Can you tell me how the wires are routed from the genset? Do the
outputs L0 L1 L2 go to the transfer switch before they go to the
breaker panel? Is there any other components in between? Is there an
AC wiring diagram available for the coach>

Thanks
Andy


--- In WanderlodgeForum@yahoogroups.com, "Jeff Miller"
wrote:
> You have an open neutral somewhere between the genset and load
center.
> Try cycling the transfer switch first.
>
> - Jeff Miller
> http://www.wanderlodge.net
> http://www.millercoachworks.com
>
>
> --- In WanderlodgeForum@yahoogroups.com, "awojteczko"
wrote:
> > Hello,
> >
> > I wonder if I can get some help with my generator problem?
> > The generator runs well but my AC voltages are 112 and 147 volts
ac
> on
> > legs one and two. When I plug in a vacuum cleaner it will barely
turn
> > the motor. If I turn the hot water heater on the relay under the
sink
> > chatters like crazy. Could this be a brush problem in the
generator?
> > If anyone has had a similar problem and could point me in the
right
> > direction it would be very much appreciated.
> >
> > Thanks,
> > Andy
> > 88WB40
> > Caledon East, Ontario, Canada