Help with generator problem, AC voltage
|
05-07-2005, 03:16
Post: #7
|
|||
|
|||
Help with generator problem, AC voltage
There is a wiring diagram for the 12.5 Kubota/Kohler genset, and for
your coach's 240v wiring. The 240v wiring runs from the genset to the breaker panel near the genset, then to the transfer switch, and from there to the main breaker panel in the rear of your coach. If someone has replaced the original Pacs 1500 inverter with a larger inverter/charger it is possible that the power goes to the new inverter between the transfer switch and the breaker panel. - Jeff Miller http://www.millercoachworks.com http://www.wanderlodge.net --- In WanderlodgeForum@yahoogroups.com, "awojteczko" wrote: > Hi Jeff, > > I assume the transfer switch is the OFF, GEN, 50, 30 position switch > by the entrance step. I have cycled this switch a number of times. > The previous owner has installed a plate with sound deadner on it > between the engine bell housing and generator assy. I have not > figured out how to remove this plate to get access to the generator. > Can you tell me how the wires are routed from the genset? Do the > outputs L0 L1 L2 go to the transfer switch before they go to the > breaker panel? Is there any other components in between? Is there an > AC wiring diagram available for the coach> > > Thanks > Andy > > > --- In WanderlodgeForum@yahoogroups.com, "Jeff Miller" > > > You have an open neutral somewhere between the genset and load > center. > > Try cycling the transfer switch first. > > > > - Jeff Miller > > http://www.wanderlodge.net > > http://www.millercoachworks.com > > > > > > --- In WanderlodgeForum@yahoogroups.com, "awojteczko" > wrote: > > > Hello, > > > > > > I wonder if I can get some help with my generator problem? > > > The generator runs well but my AC voltages are 112 and 147 volts > ac > > on > > > legs one and two. When I plug in a vacuum cleaner it will barely > turn > > > the motor. If I turn the hot water heater on the relay under the > sink > > > chatters like crazy. Could this be a brush problem in the > generator? > > > If anyone has had a similar problem and could point me in the > right > > > direction it would be very much appreciated. > > > > > > Thanks, > > > Andy > > > 88WB40 > > > Caledon East, Ontario, Canada |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Help with generator problem, AC voltage - awojteczko - 05-06-2005, 13:07
Help with generator problem, AC voltage - Jeff Miller - 05-06-2005, 14:25
Help with generator problem, AC voltage - George Lowry - 05-06-2005, 15:30
Help with generator problem, AC voltage - awojteczko - 05-07-2005, 01:34
Help with generator problem, AC voltage - awojteczko - 05-07-2005, 01:42
Help with generator problem, AC voltage - Jeff Miller - 05-07-2005, 03:12
Help with generator problem, AC voltage - Jeff Miller - 05-07-2005 03:16
Help with generator problem, AC voltage - Hovda, Craig - 05-09-2005, 12:57
Help with generator problem, AC voltage - Byrne Lobdell - 05-10-2005, 00:10
Help with generator problem, AC voltage - Stephen Birtles - 05-10-2005, 00:32
Help with generator problem, AC voltage - freewill2008 - 05-10-2005, 04:40
|
User(s) browsing this thread: 3 Guest(s)