RCA back-up camera

[Keith Strehle]

Thanks, I thought we were talking about the same camera? Perhaps
someone who still has the old RCA camera will chime in. I'll post
the model number later...

Keith
84FC35


--- In WanderlodgeForum@yahoogroups.com, "amweath"
wrote:
>
> I have a very small aftermarket camera. There is no connecter .
> Four leads come out of the camera. Power (12V.), ground, audio, and
> video. The 12V. lead goes to green #28 lead that gets power when TV
> is turned on. The gnd goes to a coach chassis ground. The video
goes
> to a coax which goes the the TV chassis.The audio is unused.
>
>
> Art Weatherly
> Riverside Ca.
> '85 PT36
>
>
> --- In WanderlodgeForum@yahoogroups.com, "Keith Strehle"
> wrote:
> >
> > Thanks for the info Art. Can you tell me if the multi-pin
> connector
> > on yours was being used? Or were there only the 12V leads and
the
> > small cam-lock cable?
> >
> > Keith
> > 84FC35
> >
> > --- In WanderlodgeForum@yahoogroups.com, "amweath"
> > wrote:
> > >
> > > Keith,
> > >
> > > I'm also trying to get mine working. I took the camera to an
> > > electronics store that dealt in security systems. They were
able
> to
> > > test
> > > my camera - it works fine. I've traced my trouble to a broken
> lead
> > > going from the camera trigger relay to the TV on/off panel above
> > > the drivers head. The problem is that it isn't obvious where
the
> > > lead broke off. This after two days off tracing leads.
> > >
> > > Good luck
> > >
> > > Art Weatherly
> > > Riverside Ca
> > > '85 PT36
> > >
> > >
> > >
> > >
> > >
> > > --- In WanderlodgeForum@yahoogroups.com, "Keith Strehle"
> > > wrote:
> > > >
> > > > Hey everyone, I have an RCA back up camera in my 84FC35.
> > (original
> > > > equip?) I removed it yesterday and hope to test it somehow.
> Any
> > > > suggestions? I know there is power to the camera and the
> monitor
> > > > works.
> > > >
> > > > Also, there are three connections on the back of the camera.
> One
> > > for
> > > > the 12V, one is a single pin cam lock type and the third is a
> > > round
> > > > multi pin connection. There is not a cable for the multi pin
> > > > connector. Should there be a cable for the multi pin
> connector
> > or
> > > is
> > > > it not required?
> > > >
> > > > Thanks, Keith
> > > > 84FC35
> > > >
> > >
> >
>