Water pump

[David Brady]

Pete,

My Microphor also acted up when I installed the
Shurflo Extreme constant pressure pump. I found
that I could get it to behave by decreasing the water
flow at the water distribution manifold. When the water
leaves the pump, my coach has a set of ball valves that
the water passes thru before the final destination. Your's
is probably similar. I turned down the flow to the toilet
and it works fine. I'm not sure if the problem with the
Microflor is flow rate or pressure or both, but turning
down the flow rate does fixed it for me.

David Brady
'02 LXi, NC

Pete Masterson wrote:

* The Microphor will not flush properly when the water pressure is
above spec. The work around is to flip open the sink faucet and
"Instantaneously" hit the flush lever. The pump always delays for a
microsecond, so the pressure drops sufficiently for the toilet to
flush before the pressure goes back up.



[Non-text portions of this message have been removed]