8V92 Won't cut off

[Bryan Altier]

This past Saturday drove to Road Atlanta for a race. Upon arrival I
hooked up to two 30 amp power outlets. Switched the power swith over
to the 30 amp side. During this time the engine was running. After
getting hooked up I went to stop the 8V92 and it would not cut off by
the key. I checked the rear switch and could not find anything
wrong. I was about the disconnect the batteries when I decided to go
back and turn everything "off" on the power switch that way I could
make sure that the converter would not be giving 12 volt to the engine
to keep it running. I turned the power switch to off and then the
engine cut off with the use of the key as it should. Has worked fine
since then. Any ideas what was going on ? Note that this was the
first time in several months that I had used the 2 30 amp connections
and switched the power swith to the 30 amp side.

Bryan Altier
Greenville, SC
88 WLWB40 "Xanadu"