Remco Driveshaft Install On Toyota Tacoma
|
11-02-2007, 02:42
Post: #4
|
|||
|
|||
Remco Driveshaft Install On Toyota Tacoma
Eric:
We have a double cab SR5 4x4. Fabulous vehicle. However they are a litle heavy at 4300 lbs. The cable comes in on the hump right beside the driver. I find that if you connect the disconnect a few seconds after start up the idle has slowed down juts the right amount for a quick coupling. It takes a little practice. Remco used sheet metal screws to attach the cable to the floor. I would have attached the cable to the reinforced parts of the floor. I had to fix mine twice. Blue Ox recommends a reciprocating saw to cut the front crossmember. I had to grind mine afterwards and the brackets still would not fit. I did not have a torch to heat them up and could not bend them by hand. Finally used the "fork ears" on our 6 yard waste bin . Hooked one end of the bracket in the ear and bent it outward. Did the same for the other side. After clamping the bracket to the frame I used a huge c - clamp to draw the bracket tight to the frame. I figure Blue Ox was out by 3/8 of an inch!! Many Blue Ox installations require you to butcher the vehicle. The truck tows really well. Good Luck |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Remco Driveshaft Install On Toyota Tacoma - Eric Johnson - 11-01-2007, 11:57
Remco Driveshaft Install On Toyota Tacoma - birdshill123 - 11-01-2007, 12:22
Remco Driveshaft Install On Toyota Tacoma - Eric Johnson - 11-01-2007, 13:31
Remco Driveshaft Install On Toyota Tacoma - birdshill123 - 11-02-2007 02:42
Remco Driveshaft Install On Toyota Tacoma - mbulriss - 11-02-2007, 05:09
Remco Driveshaft Install On Toyota Tacoma - birdshill123 - 11-02-2007, 10:10
Remco Driveshaft Install On Toyota Tacoma - Eric Johnson - 11-03-2007, 01:22
Remco Driveshaft Install On Toyota Tacoma - Eric Johnson - 11-03-2007, 01:42
Remco Driveshaft Install On Toyota Tacoma - John - 11-03-2007, 02:07
Remco Driveshaft Install On Toyota Tacoma - Eric Johnson - 11-03-2007, 02:49
Remco Driveshaft Install On Toyota Tacoma - Jack & Donna Smith - 11-03-2007, 03:45
|
User(s) browsing this thread: 1 Guest(s)