Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
86 PT40 turning radius?
11-02-2007, 11:12
Post: #4
86 PT40 turning radius?
Greg,
Did you dump the tag axle before attempting the turn.
Howard T., Sowega, 86 PT40

----- Original Message -----
From: Greg Young
To: WanderlodgeForum@yahoogroups.com
Sent: Friday, November 02, 2007 3:24 PM
Subject: Re: [WanderlodgeForum] Re: 86 PT40 turning radius?


We went out to an empty dirt lot (so we'd leave nice easy to measure tire
tracks). It's 85 feet full diameter, outside wheel to outside wheel, fully
locked. Bigger than you'd expect. I'll be interested to see if anyone comes up
with a different number - that seemed bigger than I expected.

In advance of eventually building a nice new pad and ramp to it on the
property, we now have our bird's front end perched on two home built ramps 18"
up on one side and 16" on the other. I'll post a pic to the group when I get a
chance...

Hope everyone had fun in Georgia!

Greg Young
86 PT40 as yet un-re-named
Escondido, CA

----- Original Message ----
From: sfedeli3 <sfedeli3@...>
To: WanderlodgeForum@yahoogroups.com
Sent: Thursday, November 1, 2007 4:29:58 AM
Subject: [WanderlodgeForum] Re: 86 PT40 turning radius?

Hi Greg,

While I have never "measured" the radius with a tape, I usually
need 4 lanes and a wide berm to turn mine around. Assuming 12' lane
widths (and I am occupying one) that would put the outer radius of my
turning circle at around 60 feet, assuming that the wheels are turned
before starting into the turnabout. Now that you have brought it up,
I'll probably go to the nearest empty lot and find out! If you do the
same, please share it with us.

Shane Fedeli
85PT40
Hershey, PA

--- In WanderlodgeForum@ yahoogroups. com, Greg Young wrote:
>
> Anybody happen to know the actual turning radius of an 80s PT40?
Looked in the Blue Book and could not locate the info, and did a forum
search and also came up blank. We have to grade a ramp and a pad for
our bird and it would be helpful to know the geometry...
>
> Thanks!
> Greg Young
> 86 PT40 as yet un-re-named
> Escondido, CA
>

[Non-text portions of this message have been removed]






------------------------------------------------------------------------------


No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.486 / Virus Database: 269.15.19/1105 - Release Date: 11/2/2007
11:04 AM


[Non-text portions of this message have been removed]
Quote this message in a reply
Post Reply 


Messages In This Thread
86 PT40 turning radius? - Greg Young - 10-31-2007, 08:47
86 PT40 turning radius? - sfedeli3 - 11-01-2007, 00:29
86 PT40 turning radius? - Greg Young - 11-02-2007, 08:24
86 PT40 turning radius? - Howard O. Truitt - 11-02-2007 11:12
86 PT40 turning radius? - Greg Young - 11-03-2007, 22:32



User(s) browsing this thread: 1 Guest(s)